Primrose Awnings Colour Changing RGB LED Light Kit for 2m Projection Patio Awnings

This LED light kit consists of, LED light reel, 10m transformer cable/plug and remote control. This kit is very quick and easy to install, please follow our helpful step-by-step guide below: Step 1: Lay out the Kit The best way to begin installation is to lay all of the parts on the ground first to make sure that nothing is tangled and to remove the LED lights from the reel. Step 2: Align Correctly It is important to place the cable under where the awning arm bends. Allow the cable to be slightly slack in order for the awning arm to bend when closed without pulling the LED lights out of place. Step 3: Remove Stickers The LED light strips will have red stickers on the back, please peel these stickers off and stick to the awning arms. It is a good idea to peel the stickers from the lights as you attach them to the awning arms in order to avoid anything else sticking to the lights. Step 4: Attach LED Strip You can now stick the LED Light Strip to the awning arm whilst slowly peeling the red sticker from the sticky backing. Step 5: Hide Cable wires There will be approximately 5m cable wires connected onto the strip. These wires will go across the front bar in order to keep them hidden. Step 6: Attach other LED Strip You can now stick the other LED Light Strip to the other awning arm. Step 7: Connect Controller/Transformer The next step is to connect the controllers and transformer together. The transformer cable is 10m long and must be kept indoors or outside in a waterproof box. The LED light strip is waterproof but the controller and transformer are not, please keep this in mind when installing. Step 8: Ready to go! Now simply plug everything in and use the handy remote control to change the colours and sequence of the lights. Sit back, relax and enjoy! | Primrose Awnings Colour Changing RGB LED Light Kit for 2m Projection Patio Awnings