Extra Large Glovezilla Titan Armour Needlestick Gloves

Lined with two layers of steel mesh to withstand 14.4 newtons of puncture protection in turn reducing risks and providing a barrier against puncture wounds and injuries are these specially designed Glovezilla safety gloves. Long-lasting with an ergonomic design for ultimate comfort alongside a vibrant green latex coating on the palm and finger tips for greater grip and improved dexterity allowing the wearer to work for extended periods without discomfort or encountering handling inconveniences caused by a poor design. These Titan Armour gloves provide protection in a range of work environments making them suitable for many industries including but not limited to manufacturing and construction. Safety glove size guide To find your glove size measure around your hand with a tape measure across your palm. You should use your dominant hand the right if you are right-handed and the left if you are left-handed. If you need to convert your glove size use the following general information: Small:7 (178-203mm) Medium: 8 (203-229mm) Large: 9 (229-254mm) Extra Large: 10 (254-279mm) Achieved highest rating in official testing for tear cut & puncture resistance Latex coating provides a superb grip durability and excellent flexibility Ideal for heavy duty construction glass handling manufacturing and more Superior cut protection provided from two layers of strong lined steel mesh Ability to withstand some contact heat; achieved rating of 2 in official testing ASTM F2878; 14.4 newtons of puncture protection (hypodermic needle) Compliant with EN407: 2004 for thermal risks under contact heat Compliant with the latest safety regulation EN388: 2016 2.X.4.4.F Understanding Rating Markings for Safety Gloves The higher the number or letter rating the better the performance. Scale of 1-4.Tested for the following: Abrasion Resistance (cycle) Blade Cut Resistance (coupe test/index) Tear Resistance (newton) Puncture Resistance (newton) and Cut Resistance TDM Test ISO 1399 scale A-F. 2: Dependent on the number of turns until a hole appears in the material X: Not tested or not applicable 4: The force required to tear the glove material apart is measured 4: Based on the amount of force required to puncture the material with a tip F: Determination of resistance to cutting by sharp objects. An alternative cut test recommended for cut protection gloves