Mapei Silancolor Cleaner Plus

High-Penetration, Mould- and Algae-Resistant Hygienising Treatment. Mapei Silancolor Cleaner Plus is a water-based, odourless cleaning solution designed to treat surfaces affected by algae and mould before applying protective coatings. It penetrates deeply into substrates, providing a thorough hygienising action that removes biological growth and prepares the surface for subsequent treatments within the Silancolor Plus system.. Key Features & Benefits. Deep Cleaning: Effectively removes algae and mould from deteriorated surfaces.. Surface Preparation: Prepares substrates for the Silancolor Plus protection system.. Odourless & Solvent-Free: Suitable for use in enclosed or poorly ventilated areas.. Flexible Application: Can be applied neat or diluted up to 1:3 with water, depending on contamination levels.. Easy Application: Apply using a low-pressure manual spray gun or brush.. Product Details. Packaging: Available in 1 kg and 5 kg plastic drums.. Appearance: Transparent fluid liquid.. Density: Approximately 1.01 g/cm³.. Application Temperature Range: +5°C to +35°C.. Consumption: Approximately 0.2–1.0 kg/m² (ready-to-use solution), depending on substrate porosity and contamination level.. Waiting Time Before Painting: 12–24 hours, ensuring the surface is completely dry.. Storage: 24 months in original unopened packaging, stored between +5°C and +30°C.. Application Instructions. Surface Preparation: Ensure surfaces are clean, sound, and dry. Remove any loose material, oil, or grease. Repair any cracks or damaged areas with suitable Mapei repair mortars.. Product Preparation: Stir Silancolor Cleaner Plus thoroughly before use. Depending on the level of biological contamination, it can be applied neat or diluted up to 1:3 with water.. Application: Apply the product evenly using a low-pressure manual spray gun or brush. Allow it to penetrate the surface for a few minutes.. Cleaning Action: While the surface is still damp, remove algae and mould residues with a brush. Repeat the application if necessary to ensure thorough cleaning.. Drying: Allow the treated surface to dry completely, typically 12–24 hours, before applying subsequent products from the Silancolor Plus system.. Limitations. Do not apply on metal surfaces.. Do not apply if the temperature is below +5°C or above +35°C.. Do not apply on wet surfaces or if rain is expected within 8 hours of application.. Cleaning of Tools. Clean all tools and equipment with water immediately after use, before the product dries.