EVERBUILD® 206 Strike Release Oil – 5 Litre

High-Performance, Biodegradable Release Agent for Concrete Formwork. EVERBUILD® 206 Strike Release Oil is a premium-quality, water-based chemical release agent designed to facilitate the easy removal of concrete shuttering, leaving clean and well-formed edges. Its solvent- and mineral oil-free emulsion is based on biodegradable synthetic oil, making it environmentally friendly and suitable for various mould materials.. Key Features & Benefits. Biodegradable & Eco-Friendly: Formulated without solvents or mineral oils, reducing environmental impact.. Versatile Application: Suitable for use on moulds made from wood, metal, polypropylene, ABS, polyurethane, and other plastics susceptible to damage by conventional release agents.. High-Quality Finish: Produces a stain- and blemish-free concrete surface with minimal blowholes.. Excellent Adhesion: Clings effectively to vertical mould surfaces, ensuring consistent coverage.. Protects Formwork: Guards against steel corrosion and early ageing, extending the lifespan of moulds.. Ready to Use: No dilution required; apply directly by spray, brush, or roller.. Ideal For. Smooth non-absorbent formwork.. Absorbent formwork.. Heated formwork (up to 70°C).. Textured formwork.. Product Details. Packaging: 5-litre plastic jerry can.. Appearance: White liquid.. Density: Approximately 0.97 g/cm³.. pH Value: 8.0 ± 1.0.. Coverage:. 50–60 m²/litre for steel and plastic.. 40–50 m²/litre for coated plywood.. 20–30 m²/litre for untreated timber.. Shelf Life: 6 months from the date of manufacture when stored in undamaged, unopened original containers.. Storage Conditions: Store in dry conditions at temperatures between +5°C and +25°C. Protect from direct sunlight and frost. If frozen and/or if precipitation has occurred, the product may be used after thawing slowly at room temperature followed by intensive remixing.. Application Instructions. Surface Preparation: Ensure all formwork is clean and dry, with any residues of rust or concrete removed.. Application: Stir thoroughly before use. Apply undiluted using a spray, brush, or roller, ensuring a thin and even coverage.. Drying Time: Allow an evaporation period of 20 minutes at +20°C before casting concrete.. Note: Avoid over-application, which can result in dusting of the concrete surface. Any excess material in the bottom of the moulds should be mopped up prior to the placement of the concrete.. Limitations. Apply only a thin film; overdosing may cause dusting.. For new and unsealed timbers or other highly absorbent formwork, pre-treatment is recommended with a second coat prior to use.. Cleaning of Tools. Clean tools and equipment with water immediately after use. Cured material must be removed mechanically.