Jackson's : Birch Plywood : 9mm : Relief Woodblock

Birch Plywood Is Widely Used By Artists For Producing Woodcuts And Printing With Oil Or Water-based Ink. The Timber, Grown In A Cold Climate, Is Dense And Fine-grained. Jackson's Birch Plywood Has Layers Of Birch Throughout The Core And Therefore Has Fewer Voids Than Other Plywoods. You May Prefer To Sand The Surface With Some Fine Paper Before Use, Ensuring That You Preserve The Flat Surface Of The Block And Some Artists Coat The Surface With A Thin Layer Of Shellac Or Polyurethane Varnish Prior To Cutting, But This Is Not Essential To Preparation. The Wood Can Be Brushed With A Wire Brush To Emphasise The Grain So That It Will Show Through In The Printing And Be Incorporated Into Your Image.Please Note, These Are Sold As Single-sided Blocks, You Are Likely To Find A Plug On The Reverse That May Print If You Choose To Use That Side Too.