V-TUF Super Series XHDH300SS-KIT1 - 200BAR 13L/min direct drive pump - fits GX160 & GX200 - With Banjo Unloader

200 Bar (3000 PSI) Industrial Pump with 3/4" Shaft suitable for 3/4" horizontal shaft engines such as Loncin VLCP07 and HONDA GX160 . The flow rate of 13 litres per minute is suitable for most water mains supplies. The XHDH300SS-KIT1 comes complete with unloader valve with 1/2F inlet and 3/8M female outlet. Note: the pressure must be set to unload at no more than 200 BAR (3000PSI). See safety note below: Inlet filter recommended options include:VIEW: Outlet fitting option: B14.9191 or B14.9191SS MSQ male to 3/8F coupling. VIEW: MSQ - QR COUPLINGS HP The XHDH300SS pump comes lubricated complete with V-TUF PRESSURE LUBE PL500. OPTIONAL EXTRAS: C7.038BPKIT Pump priming valve kit ; E1.1012KIT PUMP SUCTION KIT (2m) ; PL500 V-TUF Pressure Lube (for pump top up) Suitable replacement pump for WW909 PUMPS ; WW907 ; WS430110057-s PUMPS engine mounted pumps. Fits directly on to 3/4 inch male shaft engines Recommended replacement pump kit to the VT5 , WW909 PUMPS ; WW907 ; WS430110057-s , TT1513 CVB SERVICE KITS: C0.193 (Unloader valve) PL500 (Pump oil) x1 IMPORTANT SAFETY NOTE : BEFORE powering the system: 1. the unloader valve MUST be set at MINIMUM pressure; 2. The bypass port MUST be open; 3. Then set the unloader to the required pressure (which MUST be LESS than the maximum unloader pressure of the unloader valve AND LESS than the maximum pressure of your equipment); 4. Set the locking nuts so this pressure (the running pressure and the lock line pressure) cannot be exceeded. CAUTION: This is high pressure equipment and if the above safety and set up rules are not followed, serious damage to equipment and injury to humans can occur. The caps and joints can be blown clean out of their threads which cause dangerous projectiles. Please be free to ring 01522 787978 if you need any assistance.