Stack Pro Control Turbo Boost Pressure Gauge - 1.0 To +2.0 Bar, Black

The Pro Control range from Stack offers so much more than a conventional gauge. They give the user total control and awareness of critical engine functions. By using Stack's precision stepper motor for needle movement and solid state sensors, accuracy is better than 2% with the reliability you would expect from a high quality product such as this.User configurable full dial colour change alarm warningFast, smooth and accurate stepper motor needle drivePeak value tell tale memoryConfigurable back light colour with 7 different colour options0-5V output for ECU or data loggersOutputs to operate electrical circuits to retard ignition or operate an intercooler spray bar or water injection system when a pre-set boost level is reached52mm gauge diameterFeatures of the Pro Control Turbo Boost Pressure Gauge include:Full Dial Alarm Warning - User configurable minimum and maximum boost pressure parameters can be set along with one of 7 different warning colours assigned to each parameter. For example, if a high boost pressure level is set at 1.5 bar, then if the gauge reads above 1.5 bar the dial face changes to the colour you have selected to warn you. If the pressure increases further by 10 percent or more then the gauge flashes rapidly to further alert the driver. The same applies for low boost pressure.Pro Control - The pro control feature activates low or high outputs whenever the user defined alarm level outputs are exceeded. For example when the high boost pressure alarm is activated the pro control output can be used to operate items such as an ignition retard unit or intercooler spray bar.Peak Recall - The peak recall function simply informs you of the highest and lowest boost pressure readings since the memory was last reset.Configurable Back light - The LED back light has 7 user selectable colours for maximum visibility and readability. Colour options are white, red, yellow, green, blue, purple and turquoise.The gauge comes complete with all necessary wiring and a solid state sender unit (part number (ST262249) which requires a push fit boost pipe to be connected (not included).