Muc-Off Rain Shield Re-Proofer

The Muc-Off Rain Shield Re-Proofer is designed specially for those all weather riders who need that extra bit of waterproof protection.PFC free, water-based formulaNot harmful for the environment or to youHelps to repel wet mud and grime and protects against ground-in stainsWill not impact breathability of garmentsExtends life and performance of garmentsEasy to apply, supplied in a spray bottleCan be used on any technical or waterproof/water repellent fabric including Gore-Tex, Polartec, Pertex, eVent, softshell clothing, hardshell clothing and down-filled garmentsWill treat 1-2 garments per bottle!The Muc-Off Rain Shield Re-Proofer creates a cutting edge Durable Water Resistant layer on all types of technical motorcycle clothing. It is a simple to use spray on waterproofing treatment which is design to restore the factory levels of performance on all waterproof and breathable fabrics. It uses the latest technology to reduce the surface tension of the fabric and provide the very best waterproofing without impacting the breathability of fabrics. It also helps to protect the clothing from mud and ground in-stains. This spray gives a 24 hour protection and after application the water will bead and just roll off. This treatment is PFC free and is a water based formula. It is not harmful for the environment or to you. This treatment is proven to extend the life and performance of your garments and is easy to apply and supplied in a spray bottle. It can be used on any technical or waterproof/water repellent fabric including Gore-Tex, Polartec, Pertec and more. This will treat 1-2 garments per bottle.Shake bottle well before use to activate the formula.Spray all over a clean, damp garment from 10-15cm away until garment is fully treated. (We would recommend using a technical performance wash to clean the garment before application. Always follow the washing instructions on the label.). We recommend spraying in a well-ventilated, dry area.Remove any excess treatment with a clean cloth.Allow treatment to cure. Air dry by hanging up and leave to dry overnight before wearing garment in wet conditions again.The efficiency of the DWR applied to the surface of the technical apparel will gradually wear off over time with normal wear and washing, so we recommend refreshing the coating every 3 months depending on wear and washing. All waterproof clothing needs to be cared for to keep it performing at its best. Using ordinary household detergent will ultimately break down the DWR and impair the water repellent due to the heavy surfactants in these products. If you notice that water is no longer beading on the surface of your garment and soaking into the fabric then it is time to refresh with re-proofer. Best applied to a clean, damp garment for optimum results.