Polyco Polyurethane Palm Coated Safety Gloves - Size 8

Excellent cut abrasion and tear resistance with a black polyurethane coating on the palm and fingertips to provide greater grip and safer handling in wet and dry conditions Benefit from a close fit courtesy of the seamless knitted finish that is enriched with comforting materials further providing the wearer with maximum dexterity. Ideal for wear within mechanical work amongst many other working environments that require skilled hands and a secure fit. Sold in pairs these palm-coated safety gloves are available with a discounted rate available for larger orders. Safety glove size guide To find your glove size measure around your hand with a tape measure across your palm. You should use your dominant hand the right if you are right-handed and the left if you are left-handed. If you need to convert your glove size use the following general information: Medium: 8 (203-229mm) Large: 9 (229-254mm) Extra Large: 10 (254-279mm) Visually appealing grey knit finish with a black polyurethane coating Knitted to increase flexibility providing a seamless and moulded fit Most suitable to wear in working tasks where dexterity is desired Polyurethane palm coating offers good grip even in wet conditions Scored the highest rating in testing for abrasion and tear resistance Elasticated knitted wrist to assist with a secure and comfortable fit Available in three sizes: medium large and extra large Safety regulated and compliant with EN 388:2016 4.X.4.3.E Understanding Rating Markings for Safety Gloves The higher the number rating the better the performance. Scale of 1-4.Tested for the following: Abrasion Resistance (cycle) Blade Cut Resistance (coupe test/index) Tear Resistance (newton) Puncture Resistance (newton) 4: Dependent on the number of turns until a hole appears in the material X: Not applicable. The cut test ISO 13997(TDM test) was performed instead 4: The force required to tear the glove material apart is measured 3: Based on the amount of force required to puncture the material with a tip E: A knife cuts with constant speed but increasing force until breakthrough of the cut protection material. The result is given by a letter A to F where F indicates the highest level of protection.