P2 REACT TOUR PUTTER GRIP - GREY

The React Tour is an oversized grip with rounded sides, and minimal taper top to bottom and and provides a wide flat section for both thumbs to sit comfortably whilst maintaining the patented off-center shaft design. The P2 grip through its shape and soft tacky texture promotes even grip pressure, while eliminating tension in the wrist and forearms. This helps the arms to swing freely, further enhancing a more stable, consistent and reliable pendulum putting stroke. The off-centre shaft design increases ulnar deviation, which visually is a more arched wrist position throughout the stroke. This works through the off-centre shaft design lifting the hands slightly higher at address. This position limits the wrist movement and places the shaft in a flush line with both forearms. With your wrists in this positon the putter works as an extension of the lead arm. This effectively takes away the power from the hands and wrists and forces the bigger muscles of the upper body to control the putting stroke. The flat sides are in a parallel plane to the putter face, making it impossible to grip the putter any other way but with the palms square to each other and the putter face, making the control and aim of the putter face far more consistent for you. If you dont control your hands, you wont be able to control the putter face. The putter head does not move back/ forward/ up/down/ open/ closed without the influence of your hands..try moving your putter without using your hands..impossible isnt it P2 React Tour Putter Grip - Features:  Genuine P2 Putter grip Patented bottom shaft housing design Lifts your hands & locks your wrists Increases control over putter head Premium Quality PU Leather materials Available in 5 Classic colour options Authorised P2 Retailer +FREE GRIP TAPE INCLUDED WITH EACH GRIP STEP-BY-STEP REGRIPPING INSTRUCTIONS The following supplies are needed: 1.PRO-GRIP DOUBLE SIDED GRIP TAPE 2.STANLEY KNIFE / BLADE 3.NEW GOLF GRIP 4.SOLVENT WHITE SPIRITS 5.RUBBER GLOVES TO PROTECT HANDS 6. TOWEL / CLOTH STEP 1 – Remove the old grip with a Stanley blade Be sure to cut away from yourself at all times. Peel or scrape off the old grip and grip tape. Using a cloth and Mineral Spirits Grip Solvent, clean off the residue. *If removing a grip from a graphite shaft be careful to avoid damage to the shaft STEP 2 – Wrap your PRO-GRIP double sided grip tape in a spiral formation from the top of the shaft to the point where the bottom of the grip will be on the shaft. Remove the tape backing and cover the end of the shaft with extra tape. STEP 3 – Cover the vent hole in the butt end with your finger or golf tee, and pour a generous portion of Solvent such as white spirits inside the new grip. Close the open end of the grip with your hand and shake to cover the entire inside of the grip. STEP 4 – Pour the excess Mineral Spirits Grip Solvent (through the vent hole) over the entire length of the two-sided tape. Apply generously. Use a tray to catch excess Mineral Spirits Grip Solvent for use on other clubs. STEP 5 – Place the grip over the shaft butt and Push the grip entirely onto the club. Be sure to push it all the way down and align the grip as desired. This must be done while the grip tape is still wet. STEP 6 – Allow grips to dry for several hours before playing.