Tetrion Make Good Seal Waterproof 400ml

Tetrion Make Good™ Seal & Waterproof. For flat roofs, asphalt, gutters & pipework. For use on metal, walls, PVC & tarmac in all weather conditions. Exterior use only Black bitumen base Seals leaks instantly Prevents water ingress Doesn’t run or sag Tetrion Make Good™ Seal & Waterproof is an abrasion resistant and durable coating which gives effective, heavy duty protection and sealing power to flat roofing, metal panels and even vertical surfaces. It is formulated from a black bitumen base. Tetrion Make Good™ Seal & Waterproof is designed to provide a thick film without runs and sags. It gives excellent protection from stones, moisture and provides a barrier from water and dampness. Tetrion Make Good™ Seal & Waterproof offers corrosion protection, excellent adhesion to metal, gutters, driveways, pipework and a protective overcoat for sheds. It is water resistant and can be applied in all weather conditions. Tetrion Make Good™ Seal & Waterproof offers the following features: Soft healing, non-drying film Prevents water ingress Sound deadening Black bitumen base Does not run or sag Excellent adhesion Application: Remove all loose dirt & debris from the area to be coated. If required, clean and thoroughly dry the area. Remove any previous surface coatings with wire brush & abrasive paper. Lightly sand with a finer abrasive paper to give a good key and re-clean & dry. Shake aerosol can vigorously for 2 minutes minimum. Firstly test spray on a small inconspicuous area, to check spray rate, pattern and compatibility. Apply in short, even, light coats. Do not flood. Apply lighter coats to avoid runs. Apply 2 or 3 light coats, allowing 15 minutes to dry in between coats. If spray button clogs, invert can and spray to release. Clean overspray and spillages before coating dries, with white spirit-type solvent. Paint film should be touch dry in 2-3 hours and through-dry in 5-6 hours. Exterior use only. Cannot be overpainted.