Galeco Industrial Downpipe Bend - 87 Degree x 100mm Black

87 Degree Bends are used in a downpipe system to change the plane of the bend from vertical to horizontal or vice versa.They are often used instead of offset bends when the soffit is particularly wide - this enables the pipe to run neatly below the soffit rather than dropping down diagonally back to the wall as it would with a normal swan neck setup.The angle of the bend is 87 degrees rather than 90 degrees to encourage a slight fall, enabling rainwater to run away rather than sit in the pipe.The black finish offers a smart, contemporary look while providing strong resistance to fading, corrosion, and wear keeping maintenance to a minimum.Ideal for larger roof areas, this fitting is designed for easy installation and seamless integration with existing drainage systems.