MAKITA PT001GZ02 40V Max XGT Brushless Pin Nailer (Bare Unit) with MakPac Case

The PT001GZ02 is a quick firing, cordless Pin Nailer, designed for interior nailing operations where a high quality finish is required, installation of decorative mouldings, stair spindles, quadrant, furniture and more, powered by 40V Max XGT slide type battery (not included) to supply energy to the powerful 40V brushless motor. The PT001GZ02 delivers up to 6,000 shots approximately on a fully charged BL4025 2.5 Ah battery (not included). PT001GZ02 drives 5 different lengths of 23 gauge pin nails; 15mm, 18mm, 25mm, 30mm and 35mm with a magazine capacity of up to 100 pieces and is equipped with trigger lock, driving depth adjustment controlled by dial, anti-dry fire mechanism to minimise driving blanks and damaging the work surface, LED job light with pre-glow and after-glow and is IP56 rate dust and shower proof construction. The PT001GZ02 features contact arm mechanism to enable continuous nails and drag nailing; if the nose is not pressed into the work piece, the trigger cannot be pulled and low reaction force mechanism; enables easier nailing of longer pins without pushing down the pin nailer firmly to achieve high quality finish nailing. The nose tip has been designed for increased visibility; nails can be fired into the groove of base board. The PT001GZ02 is equipped with battery protection circuit designed to prevent damages to the battery from overheating, over discharge and overload current.