Nilco Nilbac Virus Control Micro Fog Liquid & Power Lance Bundle 5L

The Nilco Nilbac® Virus Control Micro Fog Liquid has been specifically developed for use with Power Lance to control viruses and bacteria on a large scale. The Antibacterial action kills 99.9% of household bacteria, viruses, yeasts, fungi, and other harmful microorganisms that can damage health, leaving a clean, purified safe environment. Nilco Nilbac® Virus Control Micro Fog Liquid’s low odour/low taint formula is perfect for use in the kitchen on food preparation and storage areas such as fridges, worktops, chopping boards and sinks. Can also be used on door handles, wall and floor tiles, tables, bins, potties, highchairs, play pens and any other non-porous surfaces to help stop the spread of bacteria and viruses. Directions for use: Ensure the area to be treated is clean and free from pets and people We recommend the use of gloves and a face mask whilst spraying to avoid inhaling the fine mist Remove sprayer from holster and stretch out the suction hose to eliminate kinks Insert the dip tube into the product bottle and screw the lid shut (if able to do so) Remove the lid cover and insert the plunger firmly into the central hole of the lid Remove battery tab Slide safety switch to unlock position and point spray nozzle at target area Press and hold red trigger to operate spray. (Adjust nozzle to desired spray pattern). Cover all areas with the Nilco Nilbac® Virus Control fine mist keeping a distance of 30 to 40 cm to avoid over-wetting Vacate the area and close all doors, allowing the products to settle throughout the area ideally overnight, or for a minimum of 10 minutes After this time open doors and windows to allow any vapours to disperse Note: Ideally this product should be used after general cleaning when the area will not be used for several hours. Not suitable for windows, mirrors, painted or varnished surfaces. If in doubt test on a small inconspicuous area before general application. Always follow appliance manufacturer’s cleaning instructions. Wash hands after use. As with all cleaners, avoid prolonged contact with skin. Avoid inhaling spray. Important After Use 1. Flush sprayer thoroughly with clean water for at least 2 minutes by pressing trigger2. Slide safety switch to LOCK position (click to lock)3. Rotate lance to storage status and return to holster Helpful HintsTo extend battery life, remove batteries if sprayer will not be used for a long period of time.Ensure safety switch is in the LOCK position when changing batteries or in storage.If the sprayer motor does not run, check the batteries are inserted correctly in the battery compartment.If the sprayer motor runs but does not spray, check dip tube is under the level of fluid. Lower the sprayer to the level of the fluid in bottle to assist priming - once primed, the sprayer should function normally.If the spray is inconsistent, the nozzle and/or the dip tube filter may be partially blocked - flush with clean water and reconnect.Do not mix new batteries with old and do not mix alkaline batteries with standard or rechargeable batteries.Hold wand and twist gently when adjusting nozzle - do not overtighten wand tip spray adjuster.Can be used with water-based cleaners, detergents, garden chemicals etc. that are recommended for spray applications, in strict accordance with the product label, and following all directions and cautions as specified on the product label.Mix to chemical manufacturer's recommendation as per the intended spray to be applied. Never mix products together unless recommended by the manufacturer.