B-G Racing Trailer Ramps - Option 3

The B-G Racing Trailer Ramps help you load and unload vehicles onto a trailer without the underside scraping on the ramp or door edge. They sit beneath your existing trailer door or ramps to reduce the incline angle, using high-density closed-cell EPS foam construction with a polyurea water-resistant coating and a combined load capacity of 2265kg (5000lb).Review the following features of these trailer ramps:High-Density Closed-Cell EPS Foam Construction: Manufactured from high-density expanded polystyrene foam with a closed-cell structure, these ramps provide high compressive strength while keeping weight low, allowing you to position them easily and support a combined load of 2265kg (5000lb) for controlled vehicle loading.Polyurea Water-Resistant Coating: Finished with a durable polyurea coating, the surface resists water ingress and surface wear, enabling you to use the ramps in wet conditions and maintain structural integrity over repeated loading cycles.Notched Leading Edge Design: The front edge incorporates a precision-cut notch that allows your existing trailer ramp or door to locate securely on top, helping you maintain stable alignment during loading and reducing the risk of ramp movement.Reduced Incline Gradient Profile: The ramp geometry is designed to extend the transition angle between the ground and your trailer ramp, lowering the effective approach angle so you can load vehicles with low ride height without underside contact.Pair Configuration with Size Options: Supplied as a matched pair and available in a range of sizes, you can select a set that suits your vehicle and trailer setup, ensuring even weight distribution and consistent support across the axle line.Reducing the loading angle helps you prevent contact between the vehicle underside and the trailer ramp during everyday transport. The high load rating and secure notched interface give you a stable platform when moving vehicles on and off your trailer. Adding these ramps to your trailer setup provides a practical solution for protecting bodywork and maintaining controlled loading.Size Options:Option 1: 106cm L x 35cm W x 11cm H, 6° angle. 3cm stepOption 2: 170cm L x 35cm W x 12.7cm H, 4° angle, 5cm stepOption 3: 188cm L x 35cm W X 18cm H, 6° angle, 6.4cm stepOption 4: 188cm L x 25cm W x 18cm H, 6° angle, 2.5cm stepSold as a pair of ramps.