EVERBUILD® 202 Integral Liquid Waterproofer- 5L / 25L

Long-Term Protection Against Water Damage for Mortar, Render & Screed. EVERBUILD® 202 Integral Liquid Waterproofer is a high-performance liquid/gel admixture designed to significantly reduce water permeability in cement-based mixes. Ideal for both above and below ground applications, it enhances the durability of mortar, render, and screed by providing long-term protection against water ingress. The inclusion of an air-entraining agent ensures improved workability without compromising the mix's integrity.. Key Features & Benefits. Enhanced Waterproofing: Dramatically reduces water permeability in mortar, render, and screed mixes.. Improved Workability: Air-entraining properties facilitate easier application without "flattening" the mix.. Non-Corrosive: Chloride-free formulation ensures it won't corrode steel reinforcements like brick ties.. Versatile Application: Suitable for pool and tank linings, roof areas, external rendering/pointing, and structures below ground level.. Compliance: Tested to BS EN 934-3 standards.. Ideal For. Waterproofing below ground structures such as basements.. Enhancing water resistance in above ground applications like mortar, render, and screeds.. Lining water tanks, silage pits, and ponds.. Product Details. Appearance: Soft mobile gel.. Colour: Red.. Packaging: Available in 5L and 25L plastic containers.. Density: Approximately 1.02 g/cm³ at 20°C.. Chloride Ion Content: Less than 0.01%.. Shelf Life: 24 months in original unopened containers.. Storage Conditions: Store in original containers between +5°C and +40°C.. Application Instructions. Mixing: Add to gauging water at a rate of 0.5 to 1.0 litre per 100 kg of cement. Alternatively, mix one part EVERBUILD® 202 with 20 to 40 parts water, then add to the mix. Ensure thorough dispersion.. Mix Design: For renders, use a mix of 3 parts sharp sand to 1 part cement by volume. For external renders, a mix of 4.5 parts sharp sand to 1 part cement is recommended.. Application: Apply render in two coats, achieving a total thickness of 18–20 mm. For swimming pools and tanks, apply an 18–20 mm thick render coat over walls and a 35–38 mm thick render over floors.. Note: Reduce the total required quantity of water accordingly (by up to 20%). Gauge the mix as stiff as possible to minimize the risk of cracking.. Limitations. Not suitable for use in structural concrete.. Not intended as a replacement for a damp-proof course (DPC).. Will not withstand permanent hydrostatic pressure.. Does not repel water; for a water-repellent finish, overcoat with EVERBUILD® WATERSEAL.. Cleaning of Tools. Clean all tools and equipment with water immediately after use. Once cured, the material can only be removed mechanically.